Free Network Appliance NCSE NS0-194 Ultimate Study Guide (Updated 190 Questions)
Get to the Top with NS0-194 Practice Exam Questions
NEW QUESTION 50
The details from within Active IQ Cluster Viewer are downloadable in which three file formats? (Choose three.)
- A. PDF
- B. CSV
- C. XLS
- D. HTML
- E. DOC
Answer: A,B,C
NEW QUESTION 51
A storage administrator explains that when he enabled a virus scan on a clustered Data ONTAP 8.3.2 SVM "svm1" at 8:00 a.m. BST this morning, all CIFS share user access was impacted and customers reported receiving "access denied" errors. After the storage administrator disabled the virus scan on "svm1", user access was restored 30 minutes later.
Now the storage administrator wants to know the root cause of the problem. When you begin collecting event management system (EMS) logs, you discover the errors shown in the exhibit.
What was the root cause of the outage after the virus scan was enabled on "svm1"?
- A. The IP address (172.16.16.74) attempting to connect to the privileged ONTAP_ADMIN$ share is not found in the list of allowed IP addresses.
- B. Virus scan is enabled on the wrong SVM.
- C. Symantec Protection Engine is not one of our supported virus scan vendors.
- D. The logged-in user (domain\\vscan_admin1) attempting to connect to the privileged ONTAP_ADMIN$ share is not found in the list of allowed users.
Answer: B
NEW QUESTION 52
You have a 6-node cluster with six identical controllers. You are upgrading from clustered Data ONTAP 8.3.1 to clustered Data ONTAP 8.3.2.
From the Upgrade Advisor, you downloaded the upgrade plan. In this scenario, which two steps are part of that plan? (Choose two.)
- A. Verify system health.
- B. Perform LIF migration of all SAN LIFs before takeover.
- C. Migrate all aggregates to the HA pair that was most recently upgraded.
- D. Set a new image as the default image.
Answer: B,D
NEW QUESTION 53
Which NetApp technology enables a volume to span across one or more aggregates and one or more NetApp nodes?
- A. Flash Pool
- B. FlexGroup
- C. FlexVol
- D. Flash Cache
Answer: B
NEW QUESTION 54
Which two vetoes can be over-ridden during an aggregate relocation or giveback? (Choose two.)
- A. Lock Manager
- B. RAID
- C. Disk Inventory
- D. Vol Move
Answer: B,D
NEW QUESTION 55
Referring to the exhibit.
Which two actions would you perform to address the system alternate-control-path (ACP) connectivity issue shown in the exhibit? (Choose two.)
- A. Turn options acp.enable off and then on.
- B. Reseat the shelf modules.
- C. Reseat the ACP cable.
- D. Perform a takeover and giveback.
Answer: A,D
NEW QUESTION 56
Which database must be installed for deployments of OnCommand Unified Manager 6.x and OnCommand Performance Manager for Linux installations?
- A. Oracle
- B. MS SQL Server
- C. Sybase
- D. MySQL
Answer: D
NEW QUESTION 57
A customer mentions that their Windows users cannot access clustered Data ONTAP 8.3.1 CIFS shares. The users see "access denied" on the Windows side.
Host name resolution is working and properly resolves IP to host name and host name to IP and the customer can ping using host name and IP. In this scenario, which statement describes the problem?
- A. iSCSI has been enabled on the SVM.
- B. NTP is not enabled on the clustered Data ONTAP 8.3.1 cluster.
- C. There is no proper route to the storage virtual machine (SVM) running the CIFS server.
- D. The time on the controller is skewed by more than five minutes.
Answer: B
NEW QUESTION 58
Microsoft SQL Server is being hosted from a Microsoft Hyper-V cluster and is mounting a LUN from NetApp storage that contains its working databases.
In this scenario, which product would be used to ensure that consistent Snapshot copies of the database are obtained?
- A. SnapManager for MS Exchange
- B. SnapManager For SQL server
- C. SnapManager for Virtual Infrastructure
- D. SnapManager for Hyper-V
Answer: B
NEW QUESTION 59
When troubleshooting the delivery failure of an AutoSupport notification, you enter the autosupport history show command.
In this scenario, what information would you expect the command output to show? (Choose two.)
- A. status of the delivery
- B. time of the last upgrade
- C. size of the AutoSupport notification
- D. IP address of the destination
Answer: A,B
NEW QUESTION 60
Referring to the exhibit.
Your customer's MetroCluster controllers have generated AutoSupport notifications with a "DISK REDUNDANCY FAILED" message.
Referring to the exhibit, which component is causing the problem?
- A. the ATTO bridges on site3
- B. the SAN switch sitel_2
- C. the SAN switch site3_3
- D. the inter-switch link (ISL) between site1 and site3
Answer: D
NEW QUESTION 61
You want to monitor and generate reports on a customer's IT infrastructure, including virtual and cloud-based components, even though the customer has not purchased or installed any ONTAP software.
In this scenario, which NetApp tool would be used to accomplish this task?
- A. OnCommand Workflow Automation
- B. OnCommand System Manager
- C. OnCommand Unified Manager
- D. OnCommand Insight
Answer: D
NEW QUESTION 62
You want to map an iSCSI LUN from a NetApp controller.
Which two components are required to accomplish this task? (Choose two.)
- A. igroup
- B. initiator WWPN
- C. iSCSI initiator
- D. FCP zoning
Answer: B,D
NEW QUESTION 63
Your storage system has experienced a double-disk failure. When is this scenario considered to be in double-degraded mode?
- A. when two disks failed on a single aggregate
- B. when two disks failed on a single disk shelf
- C. when two disks failed in a single RAID group
- D. when two disks failed on a node
Answer: C
NEW QUESTION 64
In ONTAP 9.5, the event log show command queries and displays entries from which file?
- A. messages.log
- B. ems.log
- C. bcomd.log
- D. mgwd.log
Answer: B
NEW QUESTION 65
Click the Exhibit button at the right.
A customer reports that a node panicked due to a multidisk failure.
While in take over, the customer reviewed the output of the sysconfig -a command and noticed a discrepancy in the shelf stack as shown in the exhibit.
The customer proceeded to examine the power supplies in the stack of shelves; all were functional.
Which step would you take to solve this problem?
- A. Replace the motherboard in the broken node.
- B. Replace the SAS cable from adapter 2d to shelf 1.
- C. Reseat all the disks in shelf 1.
- D. Replace the shelf chassis of shelf 1.
Answer: D
NEW QUESTION 66
A customer observes write latencies above 40 ms on a clustered Data ONTAP system with two FAS3220s for a period of several minutes each night.
During performance analysis, you discover that several back-to-back CPs occur In this scenario, which two configuration changes will reduce the write latencies? (Choose two.)
- A. Migrate the LIF with the highest network receive rate to a faster port.
- B. Move the volume with the highest write load to an aggregate with faster disks.
- C. Add more disks to the aggregate.
- D. Add flash cache cards to the nodes.
Answer: B,D
NEW QUESTION 67
A customer is installing a new system and has determined that they have a broken disk.
What information is required to open a NetApp Support case?
- A. serial number or system ID
- B. disk HBA firmware and serial number
- C. mainboard rev. id
- D. disk shelf serial number and shelf ID number
Answer: A
NEW QUESTION 68
......
NetApp NS0-194 Exam Certification Details:
| Exam Code | NS0-194 NCSE |
| Exam Name | Support Engineer |
| Passing Score | 63% |
| Exam Registration | PEARSON VUE |
Pass Network Appliance NS0-194 exam - questions - convert Tets Engine to PDF: https://troytec.itpassleader.com/NetworkAppliance/NS0-194-dumps-pass-exam.html